If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
hi guys, i hav a to4r setup and it is going in for its post run in map very soon, currently running 357rwhp on stock boost but i want it mapped to 1-1.1bar and was hoping to get some ideas of the correct fuel set up for the target 500+ fwhp?? any experiance or advice would be appreciated! cheers
hi guys, i hav a to4r setup and it is going in for its post run in map very soon, currently running 357rwhp on stock boost but i want it mapped to 1-1.1bar and was hoping to get some ideas of the correct fuel set up for the target 500+ fwhp?? any experiance or advice would be appreciated! cheers
How are you managing your system? That's something you should note it on the post.
Are you going to have supplemental fuel pump? Unless you have either supplemental, fuel pot or upgrade your existing pum you don't want to go too big on secondary as it will cause loss of power due to fuel starvation.
And I wish I could calculate but I can't so that's best I can do :/
Linear Mode
