Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Classifieds > Cars For Sale or Want

Cars For Sale or Want Want to sell you car or looking to buy? Post it here, and find a new home for it!


Reply
 
Thread Tools Display Modes
Old 07-03-2005, 05:17 PM   #1
POWERLOVER
Junior Member
 
Join Date: Jul 2005
Location: Hernando, MS
Posts: 5
Default [FS] 88 RX-7 Corvette V8 powered.
I am selling my baby. I have had the car for over three years now. I saved it from the crusher out of a salvage yard. I got it with no motor or transmission in really really rough condition. Pics of the origional condition can be seen here http://www.home.earthlink.net/~jnrwacker/RX7stuff/

I started out with a carbed SBC 2004r setup. The transmission has been modified with a shift kit, lightened governor springs, and to shift into 4th gear (OD) at wide-open-throttle. I had alot problems with the carbed setup. The whole time i was thinking that it was carb problems. I spent hundreds...no...thousands of dollars troubleshooting it. Finally, i ditched the carb for the TPI setup off of a Vette. Once i had the fuel injection up and running i realized that it was my distributor giving me the problems the whole time......anyway. I polished the TPI setup, and have a custom tune on the ECU for my cam. My cam doesnt really have a matched powerband for the TPI, but the TPI has been ported and siamesed to help get the powerband up in the RPM range of the cam and little better. It is NOT a roller cam like the TPI motors came with. It is a Hyd. Flat Tappet. A smaller cam designed for a TPI would actually make TONS more power than this cam does.

I did the entire swap myself. Including the paint, building the motor, building the transmission, and the mounts that hold it all together. The only thing that i would like to do differently, would be to use 2.5" exaust instead of 2", and mount the mufflers in the stock rear location instead of under the middle of the car.

The color of the car is a SVT Mustang color. I mixed some red pearl in the first few coats of clear to give it that "blurple" effect. The hood is aluminum, and the bulge in the middle of it is from a Mitsubishi Eclipse.

The nitrous kit is a NOS brand wet kit...150 shot. I love the power the nitrous gives the car, but it kind of makes first gear useless....except for big smokey burnouts.

I took the car to the track on June 24th and ran a best time of 12.59 @ 109.xx mph. That was really taking it easy out of the hole then spraying just before second gear. The car could be a high 11 second car easily with drag radials. And even faster than that with a different cam and a tune to match it in the ECU.

I drove the car to work daily for over two years. The only reason i quit was the fact that i now hae a 35+ mile commute to work, and cannot afford the gas. I have taken the car on SEVERAL long road trips, and it has never let me down. It is a great car to drive. The handeling that the Rx7 provides matched with the torque that the SBC provides is a great combo.

The suspension is bone stock...and needs upgrading, but the car still handles great.

I have had the car i na few car shows, and it has won awards. But there is one thing for sure....it is an attention getter. There have been many many people walk past the car thinking that it is "just another Rx7" but they cant keep walking when they see under the hood. It attracts a crowd no matter where it is.

There is really too much done to this car to mention in one thread, and it is nowhere near perfect, but if you have any questions feel free to ask.

I have well over $13,000 invested in this car. I understand that i will never ever ever sell it for that much, but i would like to keep my losses to a minimum. I would like to get $8,000.00 O.B.O. I will take serious offers.

I would also be interested in trading for a small truck. Depending on the condition/value of the truck i will also accept cash along with vehicle if it is older or in not too good of condition.
__________________

Had to move the pics.





















__________________
88 RX-7, Polished Tuned Port Chevy 355, CompCams 270/280 .470/.460 cam, 1.6 roller rockers, L98 Vette alum. heads, 200-4R transmission w/D5 stall converter.
POWERLOVER is offline   Reply With Quote
Old 07-04-2005, 09:13 AM   #2
 
black rocket's Avatar
black rocket
Full Access Member
 
Join Date: May 2004
Location: NV
Posts: 1,059
Default
I'm sure I've seen your FC somewhere... can't remember :/

I prefer rotary in my FC, but you have done one awsome job there!

Good luck selling your ride.


__________________
Drive safe and Sane
black rocket is offline   Reply With Quote
Old 07-05-2005, 07:47 AM   #3
2ROTORMOTOR
Full Access Member
 
Join Date: Mar 2004
Location: Miami
Posts: 319
Send a message via AIM to 2ROTORMOTOR Send a message via MSN to 2ROTORMOTOR
Default
I always wanted to race those v8 7's. After all that money they spent on motor tranny and all that shit, to get spanked by the original motor that came on the car... SO sad.

Not hating on your car BTW just dont agree with the choice of the swap. Although nicely done.


__________________
2ROTORMOTOR is offline   Reply With Quote
Old 08-09-2005, 10:30 PM   #4
POWERLOVER
Junior Member
 
Join Date: Jul 2005
Location: Hernando, MS
Posts: 5
Default
First $6500 takes it


__________________
88 RX-7, Polished Tuned Port Chevy 355, CompCams 270/280 .470/.460 cam, 1.6 roller rockers, L98 Vette alum. heads, 200-4R transmission w/D5 stall converter.
POWERLOVER is offline   Reply With Quote
Old 09-24-2005, 02:18 PM   #5
POWERLOVER
Junior Member
 
Join Date: Jul 2005
Location: Hernando, MS
Posts: 5
Default
bump for my wifes birthday


__________________
88 RX-7, Polished Tuned Port Chevy 355, CompCams 270/280 .470/.460 cam, 1.6 roller rockers, L98 Vette alum. heads, 200-4R transmission w/D5 stall converter.
POWERLOVER is offline   Reply With Quote
Old 09-25-2005, 02:26 AM   #6
 
black rocket's Avatar
black rocket
Full Access Member
 
Join Date: May 2004
Location: NV
Posts: 1,059
Default
Tell her Happy Bday!


__________________
Drive safe and Sane
black rocket is offline   Reply With Quote
Old 09-25-2005, 02:47 AM   #7
POWERLOVER
Junior Member
 
Join Date: Jul 2005
Location: Hernando, MS
Posts: 5
Default
it would be better if i told her the car was sold


__________________
88 RX-7, Polished Tuned Port Chevy 355, CompCams 270/280 .470/.460 cam, 1.6 roller rockers, L98 Vette alum. heads, 200-4R transmission w/D5 stall converter.
POWERLOVER is offline   Reply With Quote
Old 10-28-2005, 01:34 PM   #8
POWERLOVER
Junior Member
 
Join Date: Jul 2005
Location: Hernando, MS
Posts: 5
Default
SOLD!!!


__________________
88 RX-7, Polished Tuned Port Chevy 355, CompCams 270/280 .470/.460 cam, 1.6 roller rockers, L98 Vette alum. heads, 200-4R transmission w/D5 stall converter.
POWERLOVER is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump