| Welcome to the Rx7 Forum and Owners Club. |
|
|
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
<<<<<< Register to remove these ads >>>>>>
|
|
| 2nd Generation 1986-1992 Discussion |
05-15-2012, 10:49 PM
|
#1
|
|
Junior Member
Join Date: May 2012
Location: Santa Rosa, CA
Age: 33
Posts: 3
|
87 13b Rebuild or Replace?
i'm a new rotary fanatic, i just bought a 1987 rx7 non turbo, but it has bad coolant seals. i need help on figuring out the best way to get her up and running again. i see a alot of people say i should rebuild the entire motor or buy a jdm engine off ebay. but i dont have $900 for a master rebuild kit or even more for an entire motor. i need help 
|
|
|
|
|
|
05-29-2012, 09:22 PM
|
#2
|
|
Full Access Member
Join Date: Sep 2010
Location: Fredericksburg, Va
Age: 44
Posts: 785
|
Rebuild the motor man, if you buy another motor you will be getting a used motor. At least with the rebuild you are starting fresh. Coolant seals require a rebuild, sorry no way around it, that I know of.
|
__________________
Supercharged or Turbocharged, Boost is Boost
Big Body on 335's!!!!!
|
|
|
|
|
05-30-2012, 05:23 AM
|
#3
|
|
Junior Member
Join Date: May 2012
Location: Santa Rosa, CA
Age: 33
Posts: 3
|
i found out that the coolant seals werent blown, the guy was a complete idiot. he said there was alot wrong when theres not. the coolant system just needed to be burped of air. so motors good and runs like a champ right now
|
|
|
|
|
|
|
05-30-2012, 10:58 AM
|
#4
|
|
Full Access Member
Join Date: Sep 2010
Location: Fredericksburg, Va
Age: 44
Posts: 785
|
Good to hear man
|
__________________
Supercharged or Turbocharged, Boost is Boost
Big Body on 335's!!!!!
|
|
|
|
|
11-26-2017, 01:56 AM
|
#5
|
|
Junior Member
Join Date: Nov 2017
Posts: 1
|
Hey, I just rebuild my motor without replacing my oil seals on the rotors. But I did replace the coolant seats, side seals and apex seals and springs. If I use a different turbo than the stock, should I use blockers?
|
|
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
