If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
that sucks but boostedfc maybe right thats way the back trail is staying wet if your going into it the motor u get whole rings and gasket kit and maybe bore her over or not by it be like new. Good luck. PS u can do it.
Can't bore a rotary, but you can have a company like Goopy Performance refurbish your housing if the the plating is flaking or gone. On another note if you pull the motor apart instead of finding a replacement, this would be the time to to consider any porting or any internal upgrades.
__________________ Supercharged or Turbocharged, Boost is Boost
Big Body on 335's!!!!!
ok so im not leakin oil anymore i can get it to run if the intake is off but as soon as it put on it wont run wont start the oil i was leaking was coming from a bad pan gasket an i no longer have oil on the plugs i think i caused it when i put a vac line to the wrong place does anyone know where i can get a wirting harness at its electrical an i cant figure it out
Linear Mode
