Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 2nd Generation
Reload this Page 3 questions.....
Become a Supporting Member         Become a Preferred Vendor

2nd Generation 1986-1992 Discussion


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-11-2011, 03:44 AM   #23
rx7Noobie
Full Access Member
 
Join Date: Feb 2011
Age: 34
Posts: 116
Default
I actually used the highly sophisticated method of: Hammer+Wrench+screwdriver lol first i used the flat head screw driver stuck it in between the rotor n piston n pryed it n the piston went rite in, then for some reason i pumped the brake and the pistons went back to the rotor n when i went to pry it again the piston wouldnt budge. Im gunna try n borrow a c clamp from my woodshop class tmrw though.
rx7Noobie is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


Vendors
Auto Accessories Garage
RockAuto