If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
I have a 1994 auto rx7 that i put a 5 speed in. ive used a manual wireing harness and connected it to a power fc.im getting no power to the injectors.i am getting power to the spark plugs.there is a white connector on the harness that is to small for the white connector in the car under the dash. does anyone know what these conectors are for. maybe the reason for no power to the injectors,any suggestions on what to do ?thanks again hopefully soon to be truely at the top of the "food chain"
Last edited by apex predator; 02-26-2011 at 04:32 AM.
any idea why my injectors are not fireing? they worked fine before i did the tranny swap.i dont think it has any thing to do with the computer ,maybe the difference is in the wireing harness auto vs manual. they each have a white connector from the main harness under the dash but the automatic harnesses connector is longer than the manuals.ineed to figure out which wires go to the injectors. can anybody point me in the right direction?
I'm not proficient on FD, however, you probably are aware, there's universal auto & universal CA. You'll probably need to ck w/ power FC wiring diagram provided for proper fitment for a proper ECU.
Linear Mode
