Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 1st Generation
Reload this Page new member needs HELP
Become a Supporting Member         Become a Preferred Vendor

1st Generation 1979-1985 Discussion


Reply
 
Thread Tools Display Modes
Old 05-07-2008, 06:21 PM   #1
wanko1
Junior Member
 
Join Date: May 2008
Age: 42
Posts: 6
Default new member needs HELP
i just bought an 83 rx7. the clutch goes right to the floor i put a new master cylinder bench bleed it and all put it in and bleed the slave cylinder and still it goes to the floor does it need a new slave cylinder to and is there any special things ya need to do to bleed them?
ty
wanko1 is offline   Reply With Quote
Reply

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


Vendors
Auto Accessories Garage
RockAuto