Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 2nd Generation

2nd Generation 1986-1992 Discussion


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-13-2011, 02:05 AM   #1
Darkstar
Junior Member
 
Join Date: Apr 2011
Posts: 7
Default 1986 fc3c N/A needs motor restoration
Ok,so i bought a fc3c as a projectcar/firstcar and im kinda stumped on 3 things.
1) my engine will not lay over.it sat for 3 years and the owner said that the last
time he drove it,it over heated and he never got around to fixing it.I've done my research and i have come to the conclusion that the o-rings are bad (not sure if you'd callem shot)

2) when i press in the clutch it resists very little until it passes the brake pedal then just drops.i then have to pull it back to reset it.I just purchased a new slave cylinder cause it needs one anyway.i havent installed it yet though.

3) probably something i did.I just dropped in a new radio and when the keys are out of the car the radio still stays on.i only have 2 speakers in it and i cant getem past 20.today i added a small pioneer speaker and it wont go pass 6.any suggestions?

Any help would be nice.as far as engine wise i've considered buying this

http://www.bestofjdm.com/JDM-ENGINE-.../jdmmazda3.htm

my cars currently naturally aspirated but i plan to make it turboed down the road anyway.
Darkstar is offline   Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump