to4r single injector size - Rx7 Forum and Owners Club

Welcome to the Rx7 Forum and Owners Club.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. <<<<<< Register to remove these ads >>>>>>

		Rx7 Forum and Owners Club > Specific RX-7 Models > 3rd Generation
to4r single injector size

Become a Supporting Member Become a Preferred Vendor

3rd Generation 1993-Current Discussion

Prev

Previous Post

Next Post

Next

05-09-2010, 04:54 PM	#1
tgallier Junior Member Join Date: Jul 2009 Posts: 3	to4r single injector size hi guys, i hav a to4r setup and it is going in for its post run in map very soon, currently running 357rwhp on stock boost but i want it mapped to 1-1.1bar and was hoping to get some ideas of the correct fuel set up for the target 500+ fwhp?? any experiance or advice would be appreciated! cheers
tgallier Junior Member Join Date: Jul 2009 Posts: 3	Last edited by tgallier; 05-09-2010 at 05:36 PM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump