Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 3rd Generation

3rd Generation 1993-Current Discussion


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-28-2004, 02:21 PM   #1
wildbilly7
Junior Member
 
Join Date: Dec 2004
Posts: 1
Default 3rd gen exhaust / porting question
Hello,

I just installed a heavily ported 13B into my otherwise stock 3rd gen, and was wondering if I would still have to put in a new ECU if I add an exhaust / intake. I know it is deadly to run a 13b lean, so I don't want to risk adding more air into the engine if not enough fuel is going in. I figured the porting would bring in more fuel anyway (to balance more airflow from exhaust / intake), so perhaps a new ECU would not be needed.

Also, I live in mass., so any upgrades I do have to pass emissions

(its already passed with the ported motor)

Any help is greatly appreciated.



-Billy


__________________
1994 RX-7 - extended port
wildbilly7 is offline   Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump