Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > General RX-7 Area > TECH Support

TECH Support Technical Support for your RX7, Open 24/7/365. Post your problems and see if someone can help!


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-02-2014, 04:23 PM   #1
BLinDEpTh
Junior Member
 
Join Date: Oct 2014
Location: mid tenn
Posts: 2
Default fc no start I'm out of ideas
I have an s5 swapped into an s4. Emissions and cold start deleted. I've sorted out the electrical situation (I think). So I have spark, compression(100 lbs x3 both sides), and fuel. But only a sputter when I try to start it. I'm pulling 4lbs of vacuum at the lim and nothing at the uim. I sprayed some starting fluid in the throttle and it revved up really high then quit. The only thing I can think is I have way too much air. But any suggestions to check or try would be appreciated.


__________________
Rx7 S4 N/A with an S5 engine swap
BLinDEpTh is offline   Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump