Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 2nd Generation
Reload this Page 1990 convert w/13bnon turbo
Become a Supporting Member         Become a Preferred Vendor

2nd Generation 1986-1992 Discussion


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-17-2009, 04:07 PM   #1
cproff85
Junior Member
 
Join Date: May 2009
Age: 57
Posts: 6
Default 1990 convert w/13bnon turbo
I'm new to rx, the orginal drive train was turbo/auto somewhere a 13b standard was installed. rotary sound good and runs good while in throttle but surges when i try to cruise at slower speeds. I replaced plugs changed all fluids. Can anybody give me an idea where to start. Also the actuators on passenger side have been wired open. what's up with that.
cproff85 is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


Vendors
Auto Accessories Garage
RockAuto