If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
picked up a s6 minus the engine still has the box in it (manual).found a auto 13btt s6 enigne how much truble will i run in to puting it in?i no loom is dif no probs there got it sust and starter motor sortd but i herd that i might hav truble with the flywheel?any info would be great.
I hope I'm understanding your question right. You got rolling FD chassis with manual tranny and have FD engine. What you'll need to find is ECU for automatic. Furthermore, there's 2 types of auto ECU Ca and national standard. Make sure you get the right one.
I'm going to take shot a this one ok. You will need to match the dash harness to the engine harness if I remember right. Also when using a lightweight flywheel you would use an auto counterweight so you should be fine there.
__________________ Supercharged or Turbocharged, Boost is Boost
Big Body on 335's!!!!!
i hav the loom in my fd body and ecu so i thort id just take the auto loom off the engine and put the manual 1 on it.that was going sweet till i got to the bundle under thr plenum
and its alot differnt.thinkn mayb diffrnt series?
Hybrid Mode
