[Psycho_Dad]

heres a goodie

looking at the ignition setup for rigging an afm ecu to a 13b-rew... now on the computer diagram, it has as follows
ign output #1 L1
ign output #2 L2
ign output #spare
ign output #3 T1
ign output #4 T2
ign output #spare

now that sounds pretty simple, especially since each ignition pack is labled l1 l2 t1 and t2,

trouble for me is L1 and L2 are on the same coil pack, which is fine except their are only 2 wires coming out of that one coil pack, and their are 2 wires coming out of t1 and 2 wires coming out of t2.... so how the hell do i rig ign output #1 L1 and ign output #2 L2 to it when 1 of the 2 wires connected to the coilpack have to be rigged to the batt??

any guidence would be appreciated, or is it recomended that for my monster i run afm coil packs anyway

as usual, any help appreciated

cheers
Psyho_DAd