Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Search Forums
Reload this Page Search Results
Become a Supporting Member         Become a Preferred Vendor


Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: wanko1
Forum: 1st Generation 10-22-2008, 06:51 PM
Replies: 2
Views: 12,693
Posted By wanko1
carb issues

i have an 83 rx7 i rebuilt the carb the car idles with the choke on as soon as you go to drive it it stalls and then starts right back up and idles fine but it won't go once u start driving any ideas...
Forum: TECH Support 10-10-2008, 09:57 PM
Replies: 0
Views: 14,989
Posted By wanko1
sensors

i need help finding the location of the coolant temperature sensor,and water temp sender on a 1983 rx7 rotary motor can someone tell me where they are PLEASE.email answer to beamerman325@yahoo .com...
Forum: TECH Support 06-04-2008, 03:27 PM
Replies: 1
Views: 16,329
Posted By wanko1
83 rx7 headlight issue

i have an 83 rx7 the headlights will come up when u turn them on but when u turn them off the lights go out but they don't go back down is it a wireing issue or a motor problem.
ty
Forum: 1st Generation 06-04-2008, 03:19 PM
Replies: 0
Views: 10,911
Posted By wanko1
83 rx7 headlight issue

i have an 83 rx7 headlights go up and turn on but when u turn them off the lights go out but they don't go back down is it a wireing issue or motor problem
ty
Forum: TECH Support 05-07-2008, 06:30 PM
Replies: 1
Views: 15,865
Posted By wanko1
new member needs help

I bought a 1983 rx7 and the clutch master cylinder was empty i filled it wih recomended fluid and bleed the system clutch pedal still went to the floor so i bought a new master cylinder bench bleed...
Forum: 1st Generation 05-07-2008, 06:21 PM
Replies: 0
Views: 10,895
Posted By wanko1
new member needs HELP

i just bought an 83 rx7. the clutch goes right to the floor i put a new master cylinder bench bleed it and all put it in and bleed the slave cylinder and still it goes to the floor does it need a new...
Showing results 1 to 6 of 6

 
Forum Jump

Vendors
Auto Accessories Garage
RockAuto